Sony VGP-MR200U/E - Manual (Page 25)

Setup
25
To connect the Network Media Receiver to a network
Connect the Network Media Receiver and the computer using the supplied network cable, as shown
below.
Case 1: Connecting through a router with built-in hub (system environment C, D, G)
1 Depending on the respective system connection environment, the connection may be different. For
details, contact the technical support department of your Internet provider.
2 Use a router with built-in hub that supports 100BASE-TX. All the networked equipment must support
100BASE-TX for optimum playback experience.
Notes
• When a router with built-in hub is used in environment G, set the IP address of the computer to a fixed
value, as described in “Assigning a fixed IP address to the computer” (page 27).
• The default setting of the Network Media Receiver is “Automatic assignment (using router)”.
Depending on your system environment, this setting may have to be changed. For information on how
to do this, see page 33.
When a router with built-in hub is used in environment
G
,
nothing is connected to the WAN port.
ADSL modem, cable modem, or
similar without router capability
1
(third-party)
Router with built-in hub 2
(third-party)
Network cable
(not supplied)
Network cable
(supplied)
To NETWORK
connector
Computer 1
To NETWORK
connector
Network Media Receiver
To NETWORK
connector
Network cable
(not supplied)
Computer 2