Removing and replacing the adapter, Appendix c – Sun Microsystems FASTETHERNET 6U User Manual
Page 93

75
A P P E N D I X
C
Removing and Replacing the
Adapter
This appendix describes how to disable the adapter’s
qfe
interfaces prior to
removing the adapter from a system, and how to activate the interfaces after
replacing the adapter.
This appendix contains the following sections:
■
“Disabling the Network Interfaces and Removing the Adapter” on page 76
■
“Replacing the Adapter and Activating the Network Interfaces” on page 78
These procedures apply to both the rear-access and front-access versions of the
adapter.
Note –
The procedures for removing and replacing the adapters are system-specific
and are beyond the scope of this manual. If you are required to reinstall the cards,
you must follow the instructions outlined in your system’s service manual for the
removal and replacement of network interface I/O cards.