Sharp VL-Z400H-T - Manual (Page 22)

Preparation
Preparation
10
Inserting and
Removing a Cassette
Inserting
1
Attach the power source to the
camcorder, then slide and hold the
cassette compartment door release
as you open the cassette compart-
ment door.
• After confirmation sound, the
cassette holder extends and opens
automatically.
2
Insert a commercially available Mini
DV cassette fully with the window
facing outwards, and with the erasure
protect tab facing upwards.
3
Press the “PUSH” mark gently until
the cassette holder clicks into place.
• The cassette holder retracts
automatically.
4
Wait for the cassette holder to fully
retract. Close the compartment door
by pressing its centre until it clicks
into place.
Removing
Perform step 1 above, then take out the
cassette.
Notes:
• Do not try to close the cassette compartment
door while the cassette holder is extending or
retracting.
• Be careful not to get your fingers caught in
the cassette holder.
• Do not apply force to the cassette holder
except when pressing the “PUSH” mark to
close it.
• Do not tilt the camcorder or hold it upside
down when you are inserting or removing a
cassette. It may damage the tape.
• Remove the cassette if you will not use the
camcorder for a long period of time.
• If you do not correctly close the cassette
holder in step 3, the cassette protection
mechanism of the camcorder might eject the
cassette. If this happens, repeat the insertion
procedure.
• Do not attempt to pick up the camcorder by
the cassette compartment door.
• If the battery power is too low, you may not
be able to eject the cassette. Replace the
battery pack with a fully charged one.
• You can only use Mini DV cassettes. Large
DV cassettes cannot be used. Be sure to use
Mini DV cassettes with the i
mark.
• See pages 93 and 94 for more information on
the video cassette tapes intended for use
with this camcorder.
SA VE
RE C
Cassette compartment door release
“PUSH” mark
Erasure protect tab
VL-Z400H-006-021 04.3.23, 8:40 AM 10