Schumacher Automatic CR1 - Manual (Page 3)

• 2 •
If battery acid contacts your skin or clothing, immediately wash the area with soap and 2.9
water. If acid enters your eye, immediately flood the eye with cold running water for at
least 10 minutes and get medical attention right away.
If battery acid is accidentally swallowed, drink milk, the whites of eggs or water. DO NOT
2.10
induce vomiting. Seek medical attention immediately.
BATTERY CHARGING – AC CONNECTIONS
3.
RISK OF ELECTRIC SHOCK OR FIRE.
This battery charger is for use on a nominal 120-volt circuit. The plug must be plugged 3.1
into an outlet that is properly installed and grounded in accordance with all local codes
and ordinances. The plug pins must fit the receptacle (outlet). NOTE: Pursuant to
Canadian Regulations, use of an adapter plug is not allowed in Canada. Use of an
adapter plug in the United States is not recommended and should not be used.
An extension cord should not be used unless absolutely necessary. Use of an improper
3.2
extension cord could result in a risk of fire and electric shock. If an extension cord must
be used, make sure:
That the pins on the plug of the extension cord are the same size and shape as those •
of the plug on the charger.
That the extension cord is properly wired and in good electrical condition.
•
That the wire size is large enough for the AC ampere rating of the charger as •
specified below.
Recommended minimum AWG size for extension cord: 3.3
100 feet (30.5 meters) long or less – use an 18 gauge (0.82 mm • 2 ) extension cord.
Over 100 feet (30.5 meters) long – use a 16 gauge (1.31 mm • 2 ) extension cord.
FEATURES 4.
LED Display 1.
AC Connector 2.
Quick-Disconnect 3.
Cable
1
3
2
ASSEMBLY INSTRUCTIONS 5.
Remove all cord wraps and uncoil the cables prior to using the battery charger.
CONTROL PANEL
6.
LED Display
A.C. POWER (red) LED lit: Indicates that there is AC power supplied to the battery
charger.
CHARGING
(yellow) LED lit: Indicates the charger is charging the battery.
CHARGING (yellow) LED flashing: Indicates the charger is in abort mode.
CHARGED (green) LED lit: Indicates the battery is fully charged and the charger
is in maintain mode .
CHARGED (green) LED flashing: Indicates the battery is 80% charged and is
“ready to use”.