Sharp LL-T15A4 - Manual (Page 24)

24
6. Attach the arm to the monitor with four screws.
Note:
- The screws used to attach the arm should be M4
screws with a length of 8 mm ~ 10 mm protruding
from the surface to be attached. Using different
screws could cause the monitor to fall off or to be
internally damaged.
7. Connect the analog signal cable, the audio
cable and the power cord.
An arm or stand based on the VESA standard
(commercially available) can be attached to the
monitor.
Procurement of the arm or stand is at the
customer's discretion.
When choosing the arm to be installed please take
note of the following points.
- The arm should be compatible with the VESA
standard, and there must be a gap of 75 mm x
75 mm between the screw holes on the section
to be attached.
- The arm must not fall off or break off after being
attached to the monitor.
1. Ensure that both the monitor and computer are
switched off.
2.Unplug the power cord from the AC outlet.
3. Remove the analog signal cable and the audio
cable from the computer.
4. Press down on the stand and gently fold back the
monitor.
- Be careful not to allow your fingers to be
pinched.
- Do not overly bend the cable or add extension
cords as this could lead to malfunction.
5. Being careful not to damage the monitor, spread
out a soft cloth and lay the monitor on it display-
side down.
Instructions for attaching a VESA compliant arm
Screw used to attach arm
Arm
Part of monitor to which arm is
attached
T15A4_gb.p65 3/14/2003, 5:33 PM 24