Sharp LL-T15A4 - Manual (Page 25)

25
English
Deutsc
h
Fran
ç
ais
Italiano
Espa
ñ
ol
English
The stand may be removed.
1.Turn off the monitor, and remove the analog
signal cable, the audio cable and the power
cord from the monitor.
2. Being careful not to damage the monitor, spread
out a soft cloth and lay the monitor on it display-
side down.
3. Remove the four screws and then remove the
stand from the monitor.
CAUTION!
- Be careful not to get your fingers pinched
between the display and stand nor to let the
stand drop. These could lead to injury.
Notes:
- The stand is specially made for use with this
monitor. Once having removed the stand, never
attempt to attach it to another device.
- Once having removed the screws, store them
together with the stand and if the stand is ever
re-attached be sure to use the original screws.
Using different screws could lead to a
malfunction.
4. Follow instruction no.6 on page 24 to attach the
arm to the monitor, then connect the analog
signal cable, the audio cable and the power
cord.
Instructions for attaching a VESA compliant arm
T15A4_gb.p65 3/14/2003, 5:33 PM 25