Troubleshooting, Roubleshooting – SMC Networks EZ CARDBUS SMC8036TX User Manual
Page 17
Advertising
T
ROUBLESHOOTING
7
T
ROUBLESHOOTING
Symptom
Link LED does not light after connection is made.
Probable Causes
10BASE-T/100BASE-TX hub port, network card or cable may be
defective.
Possible Solutions
•
Check that the host computer and hub are both powered on.
•
Be sure the network cable is connected to both devices.
•
Verify that Category 5 cable is used if you are operating at 100
Mbps and that its length does not exceed 100 m (328 ft).
•
Check the network card connections for defects.
•
Replace the defective cable if necessary.
Advertising