SMC Networks EZ CARDBUS SMC8036TX - Manual (Page 7)

i
C
OMPLIANCES
FCC Class B Certification
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following conditions:
1. This device may not cause harmful interference
2. This device must accept any interference received, including interference that may
cause undesired operation.
Warning! This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from the one which the
receiver is connected to.
• Consult the dealer or an experienced radio/TV technician for help.
You may use unshielded twisted-pair (UTP) cable for RJ-45 connections.
You are cautioned that changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
Note: In order to maintain compliance with the limits of a Class B digital device, Accton
requires that you use a quality interface cable when connecting to this device.
Changes or modifications not expressly approved by Accton could void the user's
authority to operate this equipment. Suggested cable type is unshielded
twisted-pair (UTP) for RJ-45 connections.
CSA Statement (Canada)
This digital apparatus does not exceed the Class B limits for radio noise emissions from
digital apparatus set out in the Radio Interference Regulations of Industry Canada.
Le présent appareil numérique n’émet pas de bruits radio-électriques dépassant les
limites applicables aux appareils numériques de la classe B prescrites dens le Règlement
sur le brouillage radioélectrique édicté par l’Industrie