Step 7: mounting the drive, Step 8: connecting the power cable, Step 6: connecting the drive – Sony CD-R/RW User Manual

Page 7

Advertising
background image

Step 7: Mounting the Drive

Insert the CD-RW drive into computer front as shown, routing cables
accordingly. Secure drive to frame with appropriate screws.

Note:
Slide rails (not included) may be necessary if you cannot secure CD-RW
drive. Refer to your computer’s User’s Guide for more information.

Step 8: Connecting the Power Cable

Locate an available power supply cable, within computer, and connect it to
the rear of CD-RW drive as shown.

Note:
The power supply cable connector is designed to fit one way, do not force
it upside down, this could damage drive and void the warranty.

DC INPUT

GND 12V 10%

5V 5%

+

-

+

-

Step 6: Connecting the Drive

Attach flat SCSI cable to connector at rear of CD-RW drive.

Notes:
The 50 pin flat SCSI cable must be firmly attached with its red edge
(Pin 1) positioned next to the power supply connector.

If computer has a Sound Card, an Audio Cable may be connected to the
rear of the CD-RW drive. Contact a local dealer if cable is required.

Interface Connector

Pin 1

Power Supply Connector

Red Edge

Audio
Cable

Audio Out
Connector

SCSI
Flat Cable

CD-R/W Drive Unit

Mounting Screws

Audio Cable

Flat Cable

Hardware Installation 13

12 Hardware Installation

Power Supply
Connector

Power Supply Cable

Advertising