Sony CD-UX71 - Manual (Page 14)

ICD-UX71/UX81/UX71F/UX81F/UX91F 4-114-023-41(1)
1
GB
When you use the IC recorder for the
first time, or after you have not used
the IC recorder for a certain time, it is
recommended that you charge the
battery repeatedly until “ ” is displayed.
If the remaining battery/charging
indicator is not displayed, charging has
not been done properly. Proceed from
step 1 again.
* This is an approximation for the time it takes
to charge from no remaining battery power
to full battery power at room temperature.
It varies depending on the remaining power
and the condition of the battery. It also takes
more time if the temperature of the battery
is low, or if the battery is charged while you
are transferring data to the IC recorder.
If the IC recorder cannot be connected to
your computer directly, use the supplied
USB connection support cable.
Disconnecting the IC
recorder from your
computer
Follow the procedures below; otherwise,
data may be damaged.
1
Make sure that the operation
indicator is not flashing.
2
Disconnect the IC recorder from the
USB connector of the computer.
On the Windows screen, left-click
“Safely Remove Hardware” on the
taskbar, and click “Safely remove USB
Mass Storage Device.”
On the Macintosh screen, drag the “IC
RECORDER” on the desktop to “Trash”
and drop it there.
For details on disconnecting the
IC recorder, refer to the operating
instructions supplied with your
computer.
Tips
You can charge the rechargeable battery
by connecting the IC recorder to an AC
outlet using a USB AC adaptor (not supplied)
(pages 71, 106).
When replacing the battery, messages
recorded or alarm settings are not erased
even when you remove the battery.
When replacing the battery, the clock
continues moving for about 3 minutes after
you remove the battery.
Notes
While “ ” or “ ” is flashing instead
of the remaining battery/charging indicator,
you cannot charge the battery. Charge
the battery in an environment with a
temperature of 5 °C - 35 °C.





