Sierra Wireless 20070914 - Manual (Page 109)

Global Positioning System (GPS)
Rev 3.0B Feb.08 96
Tip: If the PinPoint X is using a dynamic IP, *PPDEVID needs to be
enabled.
Odometer Data in Reports
When the odometer report is enabled, the PinPoint X will
calculate distance between reports based on GPS data. The
modem’s odometer calculations can be included in the RAP
message.
Figure 10-20: AceManager : PinPoint - *PPODOM, *PPODOMVAL
• *PPODOM enables the odometer reporting.
• *PPODOMVAL is the current odometer reading in the
PinPoint X. You can set this to a number to offset the
odometer calculation, such as one‐time manual synchroni‐
zation of the PinPoint X odometer with the current vehicle
odometer.
Note: The odometer calculations of the PinPoint X may not match the
odometer in the vehicle itself. The PinPoint X odometer is not
connected to the vehicle’s, it is entirely based on calculations of GPS
readings.
I/O Event Reports
You can configure the PinPoint X to send reports to the AVL
Host based on the state of the digital inputs.
Tip: Setting up the I/O port hardware is covered in the Inputs, Relay
Outputs, and Power Status chapter.
Enable *PPINPUTEVT to have events sent to the Host server.
Figure 10-21: AceManager : PinPoint - *PPINPUTEVT
COM 1000 support