Sierra Wireless 20070914 - Manual (Page 53)

Configuring your PinPoint X
Rev 3.0B Feb.08 40
• Required variable parameters are denoted with italicized
text, example, Dn. The n is variable.
• Acceptable parameters and/or specific formats are listed
with each command.
• Most commands with parameters can be entered with ? to
read the current value (for example, AT&D? will respond
with “2” if the default has not been changed).
• Optional parameters are denoted with square brackets [ ].
• AT Commands are not case sensitive. A capital “E” is the
same as a lower‐case “e”.
• When you are using a terminal connection, if you enter a
command which is recognized by the PinPoint X, it will
respond with “OK”. If the command is not recognized, the
response will be “ERROR”.
• Those commands applicable only to certain model
numbers of the PinPoint X will be noted.
Caution: Symbols listed with commands, such as *, /, &, or ?, are
part of the command and must be included. Commands with symbols
other than * may require PassThru mode.