Siemens 2060isdn - Manual (Page 87)

Multicell system
87
I_KAP05.FM5
Gigaset 2060isdn, Inland:
8.12.98 A30853-X210-B101-1-19
Enable/disable base station change with call in progress
You can register and operate the mobile units at different
base stations from the Siemens Gigaset family, including
non-ISDN base stations.
In order to prevent a call being switched to a non-ISDN
base station, you must define the base stations to which
switching is permitted.
t Meaning: see footnote
Press if you want to cancel.
A “P” indicates a base station from which or to which
calls can be switched.
Switching to another base station while conducting a call
If you have configured a multicell system consisting of at
least two ISDN base stations, you can switch from the ra-
dio area of one base station to the other while an external
call is in progress without having to terminate the call.
If you move to the limit of the radio footprint of one base
station and want to move to the next base station, notify
your partner that you are going to interrupt the call briefly
in order to switch base stations. Then proceed as de-
scribed below in order to resume the call via the other
base station.
Resume your external call.
Ž The comfort mobile unit is idle.
.t Settings t Station settings
t Station 1-6 Select the station you want to define as “park-compati-
ble” and open the submenu.
x t Multicell config W
u x
Set the station you selected to “Parking active” (i.e. calls
can be switched to this base station).
or
u x
Set the station you selected to “Parking inactive” (i.e.
calls cannot be switched to this base station).
ON OK
OFF OK
{
• You are conducting an external call.
u
Press this softkey to change from the radio footprint of
one base station to that of the other base station.
CHANGE
t means: browse withu or u and press x to confirm Z NEXT OK