Sharp 54GS-61S - Manual (Page 10)

9
TV Operation
Channel Selection
Ꭽ Channel selector (CH /\ / CH V) buttons
Select the programme channel number you want to see, using the channel
selector buttons (
E/F).
As you press these buttons a list of channels appears.
Press the E/F again to select another channel.
Note: The channels that are in SKIP mode cannot be seen with this
buttons. Use numerical buttons to display these channels.
Ꭾ Single/Double entry selector (3)
This button selects between one or two digit channel number entry.
Ꭿ 0~9 Digit buttons
You can select channels by pressing the 0 ~ 9 digit buttons on the remote control.
For single and double digit entry see section B above.
൳ Flash-back button ( )
Press this button to switch the currently viewed channel to the previously viewed channel, and vice versa.
This function is only available in programme channel selection mode.
I.e. not when AV terminals are in use.
൴ Channel Call button (l)
Press the button to display the current programme number and the sound
mode on the screen. The name if it has been set, the remaining time for off-
timer, the real-timer and the on-timer, if they have been set, is also display-
ed on the screen.
Press the button again to make the on-screen disappear.
If the channel you are viewing has been set to be skipped with the channel
skip function, the programme number is displayed in red. If the channel was
fine-tuned, programme number will be displayed in yellow.
Press PR *
Single digit
entry mode
PR * *
Double digit
entry mode
Press Pr 01
Previously
viewed channel
Pr 12
Currently
viewed channel
Pr 01
➜ Pr 02
Pr 03
Pr 04
Pr 05
Pr 06
Pr 07
Pr 08
Pr 09
Pr 10
BCC1 01
STEREO
OFF TIMER: 120 Min.
TIMER
: 10:30
ON TIMER : 18:00
3