Sharp 54GS-61S - Manual (Page 7)

6
Auto Installation System
Your television set is provided with an Automatic Installation System which
makes Installation easier.
This new system is activated when you turn on the TV for the first time.
Procedure:
1. Connect the antenna jack in the antenna input terminal on the rear side
of your TV-set. Then connect the TV power cable to a 220 ~ 240 V
system.
2. Press the main power button ( ®), on the right hand side of the TV set,
and the AUTO INSTALLATION message will appear on the screen.
3. Put batteries into the remote control and follow the instructions on the
screen.
The TV will go through the following steps Automatically and sequentially:
Language: To select the menu language:
4. Press the RED button to select the language.
5. Press the BLUE button to continue.
Country: To select your country:
6. Press the RED button to select your country.
7. Press the BLUE button to continue and follow the instructions on
the screen.
Automatic Channel Sorting System (ASS): The TV set SEARCHES FOR
FREQUENCIES, memorises the channels found, and sorts them (according
to technical criteria) from Pr-01 of the TV, to a maximum of 99 programmes.
This tuning process may take several minutes to perform.
Editing: When the AUTOMATIC SEARCH has been completed, the "Stored
programmes" menu appears on the screen. In this menu, you can change
the order of the channels and change or give the channels a four-letter
name.
On next page is a detailed explanation of editing options about "Stored
programmes" menu.
NOTE: You may not have to follow this procedure if it has already been
done for you at the establishment where you purchased your TV. If this is
the case go on to the section entitled "Switching ON" (page 8).
If you need to repeat the AUTO INSTALLATION, read on page 17 –Auto
Channel preset…-.
Auto Installation
Pr01
01 %
Searching,
please wait.
RED BLUE
RED BLUE
Power Indicator
Main power button
54GS-61S
Power Indicator
Main power button
70GS-61S
Language
Contry
Searching