Sony CDU 5211 - Manual (Page 7)

1 2 4 3 5 6 7
10 © 2001 - Sony Australia 11 © 2001 - Sony Australia
1 - Earphone Jack Stereo mini-jack for headphones and/or powered speakers.
2 - Volume Control Control volume of earphone jack. This control has no effect
on rear panel audio output.
3 - Emergency Eject In case the Eject button isn’t working, insert a small
paper clip into this hole to eject the tray.
Note: Turn off the power before doing this manual ejection.
4 - On/Busy LED The On/Busy LED will be flashing while the CD-ROM
drive is busy.
5 - Disc Tray The user can open or close the disc tray by pressing the
Open/Close button.
6 - Play/Skip Will start playing of an Audio-CD or Skip to next track if
already playing an Audio-CD.
7 - Stop/Eject/Speed Will eject the tray if a CD-ROM is playing.
Will stop an Audio-CD playing, pressing it again will eject
the tray as usual.
Pressing this button can also change the max drive speed.
The default max speed is 40X. Press and hold for 5 seconds
to change the drive speed from 40X to 52X.
Tray out disc will reset drive speed from 52X to 40X
automatically.
Front Panel “Maximum Speed Choice” function
The CDU-5211 has a Maximum Speed Choice function where the user can select between
maximum speeds of 40X or 52X.
The drive always defaults to 40X.
To activate 52X operation press and hold the Stop/Eject button for 5 seconds.
The drive will then read the current disc at 52X speed.
When the disc is ejected the drive will default back to 40X operation.
It is recommended that 52X operation only be activated under the following conditions
- You are confident that the disc been used is in good condition and
free from marks and scratches.
- The disc is well balanced and does not have thick printed ink or
adhesive labels attached to its surface.
- The disc is not physically damaged in any maner.
Discs that have the above characteristics may reduce maximum transfer speeds due to
excessive disc vibration at 52X.
NOTE: Physically damaged discs may void warranty - refer to “Warnings &
Precautions” on page 7 of this manual.
USING THE DRIVE USING THE DRIVE