Sanyo AVP-428 - Manual (Page 26)

Setting System
MAIN MENU
Aspect Ratio
N/R
VCR mode
Default
Adjusting Screen Aspect Ratio
Press Menu to display the menu main page.
1
Press CH repeatedly to select System. +/-
2
Press Enter to access the submenu.
3
Press Enter repeatedly to select a desired aspect ratio.
4
16:9
Setting System In TV Mode
The Aspect Ratio item will be highlighted automatically.
Press Menu to display the menu main page.
1
MAIN MENU
Aspect Ratio
N/R
VCR mode
Default
Reducing Picture Noise
5
Press Enter to select Off, Auto, Strong, Middle or Weak.
Press CH+/- repeatedly to select N/R.
4
Press Enter to access the submenu.
3
Auto
Press Menu to display the menu main page.
1
Press CH repeatedly to select System. +/-
2
MAIN MENU
VCR mode
5
Press Enter to select On or Off.
Press CH+/- repeatedly to select VCR mode.
4
Press Enter to access the submenu.
3
On
When you are a watching VCR program or receiving a weak signal, set the
"VCR mode" item to "On". It helps to obtain a better synchronization and
improve the stability of the picture.
Loading Default Values
You may quickly load default values by using the Default item.
Note:
You may quickly select the screen aspect by using the Screen button on the remote control.
Setup
Picture
Sound
CH
System
OSD
TVPC
Setup
Picture
Sound
CH
System
OSD
TVPC
Setup
Picture
Sound
CH
System
OSD
TVPC
You can select the image aspect ratio between 4:3, 16:9, Panorama and
Zoom.
4:3 –– For 4:3 signal format. This mode displays a 4:3 picture at its standard 4:3
16:9 –– For 16:9 signal format. This mode displays 16:9 aspect ratio picture.
Panorama –– In this mode the picture is progressively stretched toward each side of the screen. U
Zoom –– For 4:3 letterbox signal format. This mode stretches the picture horizontally and crops the top and
bottom black bars of the picture.
se on
most non-HDTV stations. Pre-selected at the factory for your easier initial set-up.
Sometimes a grainy picture may appear on the screen because of poor signal.
This function helps to enhance the picture quality by reducing the noise.
23
Press CH repeatedly to select System. +/-
2