Kodak DP2900 - Manual (Page 21)

Setting up the Projector
21
Connecting with an S-video cable:
3. Plug the audio adapter’s white connector into the left “audio out”
connector on your video source. Plug the adapter’s red connector
into the right “audio out” connector on the video source.
4. Plug the audio adapter’s white connector into the left “audio out”
connector on your video source. Plug the adapter’s red connector
into the right “audio out” connector on the video source. Plug the
audio adapter’s other end into the audio cable.
5. Plug the audio cable into the “audio in” connector on the
projector.
The projector is compatible with these major broadcast video
standards: NTSC, NTSC 4.43, PAL, PAL-M, PAL-N, PAL-60, and
SECAM. It automatically adjusts to optimize its performance for the
incoming video. The input signal for SECAM video is similar to other
video signals and cannot be automatically detected, therefore
SECAM must be chosen manually. See “Video Standard” on page 38
for details.
in in
audio cable
S-video
audio
adapter
cable