Kodak SRP 30 - Manual (Page 166)

Tests
Calibration of New Paper, Emulsion Changes, or Correction of
a Paper Channel (Not Master Paper)
1. Print an MBL.
This provides for a calibrated condition of the system.
2. Print the PBL right after the MBL:
•
With laser point for new paper other than the master paper
or
•
Without laser point if there was an emulsion change only
Calibration of New Paper, Emulsion Changes (Master Paper)
1. Print the MBL on the previous (old) emulsion.
This provides for a calibrated condition of the system.
2. Immediately print a PBL without laser point on the new master paper.
NOTE: If the old emulsion was used up before you could print an MBL you can only
start the calibration of the new paper with a PBL calibration. However, in this
case be sure that the equipment is calibrated. Otherwise, there may be a
deviation between the master paper and all other papers. If this is the case,
perform a complete new calibration.
Completion of the New Calibration
If there is too much deviation in the paper styles, a new calibration is recommended.
1. Print an MBL on master paper.
2. Immediately print a PBL without laser point for all papers other than the master
paper.
After manipulations on the laser module or after changing the chemicals, a new
calibration is recommended:
1. Print a PBL with laser point on the master paper.
2. Print an MBL.
3. Immediately print a PBL with laser point for all papers other than the master
paper.
KODAK PROFESSIONAL SRP 30 Laser Printer 5-9