Kathrein UHF-ANTENNEN OLYMPIA AOI 65 - Manual (Page 5)

_____________________________________________________________
OLYMPIA UHF antennas AOI 65
212340
AON 65
212344
AOP 65
212348
__________________________________________________________________________________
„ General safety instructions
Please read the following safety instructions carefully and thoroughly
before you start installing the antenna, and keep observing them
during the installation.
The installation of the antenna demands a high degree of responsibility for
yourself and other people. For this reason, the installation must be executed by
an electrician (expert on his/her trade). In order to assist you, some important
safety instructions have been compiled in the following. However, these instruc-
tions are not exhaustive, as we are not aware of the local conditions.
1. Do not use the antenne for purposes other than intended by the manufacturer.
2. Only use the components as prescribed by the manufacturer and do not
modify them.
3. ATTENTION! DANGER TO LIFE!
4. When selecting the antenna site, you must consider the structural
characteristics of the building. Installation on the edge of rooftops or
buildings and on cylindrical structures could lead to increased wind loads and
vibration stress according to DIN 1055, part 4, or DIN 4131.
Non-observance of these instructions may cause exceeding of the load limit
or the vibration resistance.
5. Do not install the antenna on buildings with easily inflammable materials as rooftop, such as straw, reed or
similar materials.
6. Only step on firm, dry rooftops and protect yourself against falling down.
7. Ladders, scaffoldings, safety belts etc. must be in good order.
8. Passers-by must not be endangered by falling objects. Secure the work/danger area.
9. Mind that the technical values (e.g. wind load) of the antenna mast are not exceeded. Refer to the
manufacturer if you do not know these values. Find an overview of the masts offered by Kathrein on the last
page.
10. Mount the antenna mast on solid ground only (walls, concrete, rafters) using the clamps, dowels and screws
recommended by the manufacturer.
11. Immediately leave the roof in case of a thunderstorm!
12. Ground the antenna installation according to EN 50083-1.
Notice:
The OLYMPIA UHF antennas were designed solely for the limited purpose of receiving terrestrial TV
signals and as indoor antennas. Under the terms of DIN 4131, an antenna is reckoned an indoor antenna if
the mast length does not exceed 6 metres and if the torque needed for screwing the antenna is at 1,650 Nm
at maximum.
Do never mount an antenna under power supply
lines! Touching power supply lines with parts of
your body, with antenna parts or tools may cause
an electrical shock or serious burns.
936
.2
595/
B
/11
04/
1.
4e
Suitable for
DVB-T (B IV/V)
AOI 65
AON 65
AOP 65