Kenwood VR-716 - Manual (Page 18)

18 EN
Listening to a source component
1
Use the INPUT SELECTOR knob or keys to select the source
you want to listen to.
The input sources change as shown below:
1 “AUX”
2 “TUNER”
3 “CD/DVD”
4 “TAPE” or “MD”
5 “VIDEO1”
6 “VIDEO2”
7 “DVD/6CH”
2
Start playback from the selected source.
3
Use the VOLUME CONTROL knob or VOL +/– keys to adjust the
volume.
Normal playback
Some preparatory steps are needed before starting playback.
Turning on the receiver
1 Turn on the power to the related components.
2 Turn on the power to this receiver by pressing POWER ON/
STANDBY key.
Selecting the input mode
If you have selected a component connected to the CD/DVD, VIDEO 2
or DVD/6CH jacks, make sure that the input mode setting is correct for
the type of audio signal to be used.
8
Selecting MD/TAPE
Select the source name corresponding to the component connected to
the MD/TAPE jacks. The initial factory setting is “TAPE”. To change the
source to “MD”, follow the steps below:
1 Use the INPUT SELECTOR knob to select “TAPE”.
2 Hold down the AUTO key for more than 2 seconds.
• The source indication changes to “MD”.
• To return to the original indication, repeat procedure
2.
Setting the speaker status
Press the SPEAKERS ON/OFF key to switch the speakers on or off.
Preparing for playback
The speaker indicator lights up.
4
¢ + +
+
INPUT SELECTOR
VOLUME CONTROL
Input
Selector
VOL
INPUT SELECTOR
POWER
ON/STANDBY
SPEAKERS
ON/OFF
AUTO
*5335/16-19/EN 25/1/03, 2:47 am 18