Kenwood VR-716 - Manual (Page 38)

38 EN
In case of difficulty
Remote control unit
Cause
• No setup codes registered at the respective
input(s).
• The remote control is set to a different
operation mode.
• Batteries are exhausted.
• The remote control unit is too far away from
the main system, controlling angle is too large,
or there is an obstacle between the receiver
and the remote.
• The audio cords and system control cords are
not connected properly.
• No tape or CD is placed in the source
component.
• An attempt is made to play a tape which is
being recorded in the cassette deck.
• The remote control has not been set to the
operation mode for the component you wish
to control.
Remedy
• Register a setup code at the respective
input(s). •
• Press the any of the Input Selector keys to
select the appropriate operation mode.
• Replace with new batteries.
• Operate the remote control unit within the
controllable range.
• Connect properly referring to “Setting up the
system”.
• Place the tape or CD in the source component
which you want to play.
• Wait for recording to complete.
• Press any of the source keys or SRC Power
key to activate the operation mode for the
component you want to control before
operation.
ª
Symptom
Certain inputs cannot be selected using the
remote control.
Remote control operation is not possible.
*5335/34-40/EN 25/1/03, 2:50 am 38