Kenwood TM-D700A - Manual (Page 21)

15
3
BASIC TRANSCEIVER MODES
This section introduces you to the basic modes you can
select.
VFO mode
Press [VFO] to select. You can change the operating
frequency using the Tuning control or Mic [UP]/ [DWN].
Memory Recall mode
Press [MR] to select. You can change memory
channels, using the Tuning control or Mic [UP]/ [DWN],
where you stored frequencies and related data. Refer to
“MEMORY CHANNELS” {page 35}.
Programmable Memory (PM) mode
Press [PM] to select. You can select the transceiver
environment, by pressing [1] to
[5], that you stored in
PM channels. Refer to “PROGRAMMABLE MEMORY
(PM)” {page 42}.
Menu mode
Press [MNU] to select. You can change Menu Nos.
using the Tuning control or [
c c c c c ]/ [ d d d d d ]. Refer to “MENU
SET-UP” {page 22}.
APRS mode/ Packet mode
Press [F] (1 s), [TNC] to select APRS mode. Press [F] (1 s),
[TNC] again to select Packet mode. In APRS mode, you
can receive and transmit APRS packets. In Packet mode,
you can send commands to the built-in TNC from a personal
computer. Refer to the separate manual, “SPECIALIZED
COMMUNICATIONS” {pages 4 and 11}.
1
2
1
2
APRS mode Packet mode