Dcs code id – Kenwood TM-D700A User Manual
Page 64
58
11
4 Press [OK] to program the identified code in place of
the currently set code.
•
The DCS function will be remained ON. You may press
[TONE] to switch the DCS function OFF.
•
Press [ESC] if you do not want to program the identified
code.
•
Press [SCAN] while the identified code is blinking, to
resume scanning.
Note: Received signals are audible while scanning is in progress.
DCS CODE ID
This function scans through all DCS codes to identify the
incoming DCS code on a received signal. You may find
it useful when you cannot recall the DCS code that the
other persons in your group are using.
1 Press
[TONE] to switch ON the DCS function.
•
“DCS” appears when the DCS function is ON.
2 Press [F], [T.SEL].
•
The current DCS code appears and blinks.
3 Press [SCAN] to activate the DCS CODE ID.
•
“DCS SCAN” appears and blinks.
•
Scan starts when signals are received.
•
To reverse the scan direction, turn the Tuning control
clockwise (upward scan) or counterclockwise
(downward scan). You can also press Mic [UP]/ [DWN].
•
To quit the function, press [ESC].
•
When the DCS code is identified, the identified code
appears and blinks.