Knoll Systems HT201 - Manual (Page 10)

Connecting a PC or Macintosh
Connecting a PC or Macintosh to the Projector enables computer images for impressive presentations.
• The following display standards are supported by the HT211 (HT201 may not support some of
the higher resolutions):
VGA 640x480 for graphics VGA 640x400 for graphics XGA 1024x768
VGA 640x350 for graphics VGA 720x400 for text Mac 1024X768
VGA 720x350 for text SuperVGA 800x600
Macintosh at 640x480 Macintosh at 832x624
• If your PC
does not
support XGA
you will need
to install a
XGA graphics
board. Consult
your
computer's
owner's
manual for
your XGA
configuration.
If you need to
install a new
board, refer to
the manual
supplied with
your new
graphics board
for installation
instructions.
Notes
• Refer to the
owner's
manual
supplied with
your computer
for more
information
about the
computer
video output
requirements and any special identification or configuring required by the projector image and monitor.
• Some Macintosh PowerBooks may need to set the mirroring to off to output 800x600 dot signals.
Please consult your PowerBook manual or computer dealer for details.
Before connecting
• Turn off the components that are to be connected.
• The projector and computer will be turned on in "Using the Projector" on page 13. Do not
turn on either the computer or unit until you read this section.
• Please also refer to the manual of the video component to be connected .
PowerBook Connection Depending on the model of your PowerBook, the additional Apple
video cable adaptor may be required with the above connection.
10