Knoll Systems HT201 - Manual (Page 17)

Setting "INPUT MODE" to "YCbCr" or Component Video
When you have connected the component video (YCbCr) signal output jacks of the video
component to the RGB IN connector on the unit, set the projector to "YCbCr" to obtain better
picture quality.
1. Turn the component video image on.
2. Open the flip cover on the remote and press the menu button (to select the advanced menu).
3. Press the left/right cursor to select “COLOR”
4. Press the up/down cursor to select “SOURCE CHANGE”
Use the left/right cursor to change the source from RGB to YCbCr.
Adjusting the image from the source connected to the RGB IN connector
The Projector selects the most suitable resolutions as shown in the "Timing Chart" below
according to the incoming signals from the RGB IN connector (When "RGB" is set to
"STANDARD". However, you may need manual adjustment depending on the computer or
video component connected to the RGB IN connector. If you have any of vertical banding, noise,
dot interference, or crosstalk on the projected picture, adjust clock frequency with "PICTURE
ADJ" then clock phase with "FINE PICTURE" (see next page). You can also adjust the
horizontal and vertical position of the image.
Changing Aspect Ratio
The aspect ratio can be set individually for each input
1.
Select the input to the desired video source.
2. Open the flip cover and press the menu button
3. Use the left/right cursor to select “VIEW”
4. Display the image then use the up/down cursor to select “ASPECT”
5. Use the left right cursor to set the aspect ratio. Aspect ratios setting are shown below.
Aspect Ratio Type Means
Real
Input signal displayed without pixel replacement
Auto Projection after automatic input signal zoom in/zoom out
Direct Original aspect ratio of the image is maintained at all times
4:3 – 16:9 4:3 aspect ratio images are projected after conversion to 16:9
Adjusting the image from the source connected to the RGB IN connector
The Projector selects the most suitable resolutions as shown in the "Timing Chart" below
according to the incoming signals from the RGB IN connector (When "RGB" is set to
"STANDARD". However, you may need manual adjustment depending on the computer or
video component connected to the RGB IN connector. If you have any of vertical banding, noise,
dot interference, or crosstalk on the projected picture, adjust clock frequency with "PICTURE
ADJ" then clock phase with "FINE PICTURE" (see next page). You can also adjust the
horizontal and vertical position of the image
.
17