Terminal connection panel, Projector part identification, Installation – Knoll Systems HT201 User Manual

Page 6: Warning: carrying the projector

Advertising
background image

Terminal Connection Panel

Projector Part Identification









Installation
The distance from the projector lens to the screen determines to the size of the projected
image, therefore, you need to consider the place where you set up the projector and
screen before making connections. You also need to consider the screen size and height
of the unit and screen as other important factors.

Tip:
Although not advised, a non-glossy wall may be used as a substitute for a screen.

WARNING:

Carrying The Projector

• Ensure all cables connecting to the projector are disconnected before moving the

projector. When moving the projector, cover the lens with the sliding cap.

• Only use your Projector on a solid flat level surface. If the projector falls to the

floor, you can be injured and the projector severely damaged.

• Do not use the Projector where temperatures vary greatly. The projector must be

used at temperatures between 5 degree Celsius (41 degree Fahrenheit) and 35
degree Celsius (95 degree Fahrenheit).

• Do not expose the Projector to moisture, dust, or smoke. This will harm the

screen image.

• Ensure that you have adequate ventilation around your Projector to allow heat

dissipation. Do not cover the vents on the bottom or the side of the projector.




6

Advertising
This manual is related to the following products: