Kenwood KRF-V4530D - Manual (Page 10)

10
Preparations
OPTICAL
DVD
CD/DVD VIDEO 3
VIDEO 2
COAXIAL
OPTICAL
DIGITAL IN
Digital connections
COAXIAL
DIGITAL
OUT
(AUDIO)
Optical
fiber
cable
Connect the video signal and analog
audio signals to the VIDEO 2 jacks.
(See "Connecting video components".)
Connect the video signal and analog
audio signals to the VIDEO 3 jacks.
(See "Connecting video components".)
DOLBY DIGITAL RF
OUT (AUDIO)
COAXIAL DIGITAL OUT
(AUDIO)
OPTICAL DIGITAL OUT
(AUDIO)
PCM OUT
Optical
fiber
cable
OPTICAL DIGITAL OUT
(AUDIO)
Input mode settings
, , and (KRF-V7030D only) inputs each
include jacks for digital audio input and analog audio input.
You must select beforehand which type of input is to be used for each
connected component.
To use the analog audio input for playback instead (if, for example, you
have connected a VCR to the VIDEO2 or VIDEO3 input), you must set
the input mode for the corresponding input to the analog mode.
After completing connections and turning on the receiver, follow the
steps below.
1
2
1 (digital input, auto sound)
2 (digital input, manual sound)
1 (digital input, auto sound)
2 (digital input, manual sound)
3 (DVD 6CH input)
4 (analog input, manual sound)
1 (digital input, auto sound)
2 (digital input, manual sound)
3 (analog input, manual sound)
Select this setting to play digital signals from a DVD, CD, or LD player.
Select this setting to play analog signals from a cassette deck, VCR,
or turntable.
In the auto sound mode ( indicator lights), the receiver
selects the listening mode automatically during playback to match the
type of input signal (Dolby Digital, PCM, DTS ) and the speaker setting.
The initial factory setting is auto sound on.
To keep the receiver set to the currently selected listening mode, use
the
key to select “ ” (manual sound).
However, even when this setting is selected, there may be cases in
which the listening mode is selected automatically to match a Dolby
Digital source signal depending on the combination of listening mode
and source signal.
Setting up the system
INPUT SELECTOR
INPUT MODE
The digital in jacks can accept DTS, Dolby Digital (AC-3), or PCM signals.
Connect components capable of outputting DTS, Dolby Digital (AC-3), or
standard PCM (CD) format digital signals.
If you have connected any digital components to the receiver, be sure to
read the “Input mode settings” section on this page carefully.