Kenwood KRF-V4530D - Manual (Page 5)

5
Preparations
DSP
CLIP
A SPEAKERS B
STANDBY
POWER
MULTI CONTROL
MULTI CONTROL
LISTEN MODE SOUND SOURCE DIRECT
AUTO BAND MEMORY
INPUT SELECTOR
VOLUME CONTROL
UP DOWN
PROLOGIC 3 STEREO DOWN MIX
DOLBY
DIGITAL DTS
INPUT MODE SET UP
S-VIDEO V L – AUDIO – R AV AUX
DIMMER MONITOR
PHONES
ON/STANDBY
ON OFF
PROLOGIC 3 STEREO
DOLBY
DIGITAL
SPEAKER MUTE
TI.VOL FM
AM
MHz
kHz
PRO LOGIC
3 STEREO
DOWN MIX
DIGITAL
S.DIRECT
MONITOR
MEMO.
ST.
TUNED
AUTO SOUND AUTO SP
LFE SW
C A B
MUTE
S RS LS
R L
RDS PTY
Display
Speaker selection indicators
Input channel indicators
Output channel indicators
Band indicators
AUTO indicator
MEMO. indicator
ST. indicator
TUNED indicator
3 STEREO indicator
STEREO indicator
Names and functions of parts
Frequency display,
Input display,
Preset channel display,
Surround mode display
Speaker indicators
PRO LOGIC
indicator
S.DIRECT indicator
MONITOR indicator
DOWN MIX indicator
MUTE indicator
AUTO SOUND indicator DIGITAL indicator
For KRF-V7030D
Standby mode
While the standby indicator of the unit is lit, a small amount of current is flowing into the unit’s internal circuitry to back up the memory. This condition is
referred to as the standby mode of the unit. While the unit is in the standby mode, it can be turned ON from the remote control unit.
For
KRF-V5030D,
KRF-V4530D
1 %
Use to turn the main power ON/OFF.
2 %
Use to switch the power ON/STANDBY when
the POWER is turned ON.
3 %
KRF-V7030D
Used to make a variety of settings.
3 %
KRF-V6030D/V5030D/V4530D
Used to make a variety of settings.
4 %
Use to select the surround sound settings.
5
§
KRF-V7030D
Lights when the receiver is in the DTS mode.
∞
Lights when the receiver is in the Dolby Digital
mode.
∞
Lights when the receiver is in the PROLOGIC
mode.
∞
Lights when the receiver is in the 3 STEREO
mode.
§
KRF-V7030D
Lights when the receiver is in the DOWN MIX
mode.
6 0
Use to switch between the digital and analog
inputs.
7 (¶
Use to adjust the brightness of the display.
Use to select the REC MODE.
8 *
Use to monitor the source that is connected to
the VIDEO2/MONITOR jack.
9 &
0 *
Use for headphone listening.
! ^
Use to turn the A/B speakers ON/OFF.
! ^
Use to turn the speaker ON/OFF.
*
Use to temporarily mute the sound.
@ ¶
Use to adjust the sound quality and ambience
effects.
# )
Use to select the broadcast band.
$ )
Use to select the auto tuning mode.
% ∞
Use to select the listening mode.
^ ¡
Use to store radio stations in the preset memory.
& *
Use to pass the source material direct to the
amplifier.
* &
Use to select the input sources.
(
!
For KRF-V7030D
RDS indicators
For KRF-V6030D,
KRF-V5030D,
KRF-V4530D