Krown Manufacturing 2000DLD - Manual (Page 19)

THE MEMORY (CONT.)
Deletes a single character.
To add characters in the middle of a message:
Move to the location where you want to add material and type [CTRL] and [6] (insert). This will put
you into “insert” mode. Now whatever you type will be put into the text at the cursor position, and
the text to the right will simply move over to make room for the new material. (If you do not use
insert mode, each character you type will replace the character that was there before.)
Activates (or turns off) insert mode;
what you type is added to the
message. For example, if you type
“H” at the beginning of the message
shown above, the display on the left
will be shown.
Type [CTRL] and [6] again to get out of insert mode. To save the changes you have made, type
[CTRL] and [9].
Saves a new message.
USING THE PHONE DIRECTORY
You can store phone numbers in any of 26 memory locations. Begin by typing [CTRL] and [5] to
access the memory areas. Type [D] to indicate that you want the directory, not one of the numbered
areas. Then you’ll be asked to pick a location in the directory. The screen will first show the message
“TYPE NAME & NO. NOW,” then that message will disappear and the location’s label will appear
on the screen.
Accesses memory areas.
Chooses the phone directory. Allows
you to print phone directory
[Y] prints: [N] does not.
Chooses phone number location M
(for example).
New name and number typed into
directory location M.
Type the number to be stored, and then save the information by typing [CTRL] + [9].
Saves the message.
You can view or edit the information in a directory locations in the same ways as you would a
memory area.
17
CTRL + 6 HELLO. I1
CTRL + 7 ELLO.P M1
CTRL + 9 MEMORY SAVED
CTRL + 5 MEM 1-5 OR (DIR)
D PRINT DIR.? Y/N
or N TYPE A-Z OR 0(PW)
M TYPE NAME & NO. NOW
Adrienne 555-1234 ADRIENNE 555-1234 DM
Y
CTRL + 9 MEMORY SAVED