Krown Manufacturing KR2812 - Manual (Page 6)

6
EN
3.Never touch uninsulated telephone wires or terminals unless the
telephone line has been disconnected at the network interface.
4.Never install or modify telephone wiring during a lightning storm.
5.Never install telephone jacks in wet locations unless the jack is
specifically designed for wet locations.
6.Use caution when installing or modifying telephone lines to prevent
electrical shock and/or fire.
17.Unplug this product from the wall outlet and refer servicing to qualified
service personnel under the following conditions:
A. When the power supply cord or plug is damaged or frayed.
B. If the product has been exposed to rain or water.
C. If the product does not operate normally by following the operating
instructions.
D. If the product’s cabinet has been damaged.
E. If the product exhibits a distinct change in performance.
8.Do not use the telephone to report a gas leak in the vicinity of the leak.
9.Do not place this product on an unstable cart, stand or table. The
product may fall, causing serious damage to the product.
0.Use only the power cord and batteries indicated in this manual. Do not
dispose of batteries in a fire. They may explode.
. For servicing or replacement, you can purchase a suitable headset
through service center or retailer shop.
CAUTION
You must use a Class  power source that
supplies 9V DC and delivers at least 500mA.
Its plug must fit the phone’s DC jack. The adapter
supplied meets these specifications. Using an
adapter that does not meet these specifications could
damage the phone or the adapter.
Always connect the AC adapter to the phone before
you connect it to AC power. When you finish, discon-
nect the adaptor from AC power before you discon-
nect from the phone.
SAVE THESE INSTRUCTIONS