Kompernass PEBS 900 - Manual (Page 10)

PEBS 900 BELT SANDER
For sanding large areas. For wood, plastic and metal
Please read carefully through the following information concerning safety and proper use. Before
reading, fold out the page with the illustrations and make yourself familiar with all the functions of
the equipment. Please read the operating instructions
below and the accompanying safety
advice ƽ carefully. Use the equipment only as described and for the indicated purposes. By doing
this you will be able to work in complete safety and produce better results. Be careful to keep these
advice notes and if necessary pass them on to a third party.
PROPER USE
The belt sander is intended for dry-sanding and polishing wood, metal and paint. Always use a
sanding belt and grade of grit suitable for the particular surface you are sanding. The speed selected
should also be appropriate for the material. Any other use or modification to the belt sander shall be
considered as improper use and could give rise to considerable dangers. The manufacturer will not
accept liability for loss or damage arising from improper use.
FEATURES OF THE PEBS 900
³ Auxiliary handle ² Protective cover
· Ventilation slots ¶ Dust extraction spout
» Belt speed selector wheel º Belt adjuster screw
¿ Locking knob ¾ Tensioning lever
´ ON / OFF switch µ Dust collection bag
TECHNICAL INFORMATION
Rated consumption: 900 W Protection class: II/ Ɓ
Nominal voltage: 230 V ~ 50 Hz Weight: 3.8 kg
Belt no load speed: n
0
650 rpm Sound pressure level: Lp = 87 dB (A)
Belt /sanding speed Sound output level: Lw = 100 dB (pw)
at maximum speed: 350 m/min Vibration: < 2.5 m/s 2 (Hand-
Abrasive surface: 75 x 150 mm arm vibration)
Belt: 75 x 533 mm
The PEBS 900 belt sander has full-wave electronics with additional control electronics, overload
control, soft start and power control.
Soft start with inrush current limiting.
www.kompernass.com +++ www.kompernass.com +++ www.kompernass.com +++ w
10
t
10
manual PEBS 900 07.11.2003 11:39 Uhr Seite 10