Kompernass PEBS 900 - Manual (Page 14)

www.kompernass.com +++ www.kompernass.com +++ www.kompernass.com +++ w
14
t
CARE AND MAINTENANCE
ATTENTION: Before you carry out any work on the belt sander always pull the plug out of the
mains socket.
1) Clean the belt sander regularly. The best time is immediately after you have finished working with it.
2) Do not use any sharp objects to clean the belt sander. Do not allow any liquids to enter the belt
sander. Use a moist cloth to clean the housing - never use petrol, solvents or cleaners that attack
plastic.
3) Always keep the ventilation slots clear.
4) Remove any adhered sanding dust using a narrow paint brush. Unscrew the protective cover
²
from time to time and carefully clean out the dust channels to ensure optimum dust extraction.
DISPOSAL
The packaging is wholly composed of environmentally-friendly materials that can be disposed of at
a local recycling centre.
Please contact your local council office to find out about disposal facilities for your worn-out
electrical tools.
TIPS AND TRICKS
• Never use the same sanding belt to sand wood and metal.
• Worn or ripped sanding belts can damage the workpiece. Make sure you change the sanding belt at
the appropriate time.
• Keep the sanding belt properly tensioned so that it does not hang down too much and become
unusable due to knicks, creases etc.
You can find further practical tips in the accompanying booklet "Safety Advice".
We reserve the right to make technical modifications in the course of further development.
14
ƽ
Material / type of work Coarse sanding (grit) Fine sanding (grit) Speed
Smoothing varnish 150 320 low (1-2)
Removing rust 0 40 120 medium/high (3-4)
Plastic 120 240 low/medium (2-3)
Non-ferrous metals
(e.g. aluminium)
0 80 150 medium/high (3-4)
manual PEBS 900 07.11.2003 11:39 Uhr Seite 14