Kalorik USK AS 29091 - Manual (Page 6)

Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
Print only what is inside the frame.
6 USK AS 27222 – AS 29091 - 110127
Assembly page 6/24
Fax +32 2 359 95 50
STORAGE
When not in use, it is recommended that the thickness adjustment
button is turned down all the way, so that the blade is not flush
anymore but concealed, in order to avoid any risk of accidental cuts
or injuries.
CLEANING
• Make sure the switch has is in “0” position and that the appliance
has to be unplugged from the power supply before cleaning the
appliance
• Wipe the inside and outside of the appliance with a paper towel
or a soft cloth. It should not be washed in a dishwasher (the
platform tips to make the cleaning easier).
• Do not clean the inside or outside with any abrasive scouring pad
or steel wool as this will damage the finish.
• Do not immerse in water or any other liquid.
• Dry all parts well before storage.
REMOVING BLADE FOR DEEP CLEANING
• Switch off the appliance and unplug it from the power socket.
• To remove the blade, turn the locking device (4) located in the
middle on the blade with a coin (a US quarter works best) for
example. You have to turn the locking device counter-
intuitively: clockwise to remove, counterclockwise to tighten.
• To put the blade back into place, proceed inversely.
• Be very careful during this operation as the blade is very sharp.
IMPORTANT INFORMATION
• A lubricant paste is applied at the factory in order to ensure correct
lubrication for the first couple of usage. After this, the first time you
remove the blade, the user can remove the extra lubrication paste or
leave it. The paste is food safe. No extra lubrication will be needed
afterwards.
• Just cautiously cleaning the blade surface after use as indicated in the
user manual should avoid cross-contamination. Deep cleaning by
removing the blade shall only be necessary from time to time.