Kenwood DPX-8030MD - Manual (Page 33)

[VOL.] buttons
Adjusting the volume.
[SRC] button
Each time the button is pressed the source switches.
For the source switching order refer to <Selecting the Source>
(page 11).
[ATT] button
Turning the volume down quickly.
When it is pressed again it returns to the previous level.
[ * ] button
Adjusting the Faceplate Angle.
Basic operations
Use one lithium battery (CR2025).
Insert the batteries with the + and – poles aligned properly,
following the illustration inside the case.
Store unused batteries out of the reach of children. Contact a doctor
immediately if the battery is accidentally swallowed.
Do not set the remote on hot places such as above the dashboard.
2WARNING
Loading and Replacing the battery
— 33 —
[DSP] button
Turns <DSP(Digital Signal Processor) System> (page 17) ON and
OFF.
Selects <Sound Field Setting> (page 17).
[EQ] button
Makes <Preset Equalizer Curve Selection> (page 17).
[AUD] button
Enters the Audio control mode.
Select the Audio control, X’Over control and Amp control mode.
When the button is pressed for at least 1 second the Audio
control mode is turned OFF.
[FNC] button
Enters and exits the Function Setting mode.
Refer to <Function Setting System> (page 29).
[FM]/ [AM] buttons
[
4]/ [¢] buttons
Selects and adjusts the item.
Refer to
<Balance/ Fader Control> (page 15)/
<X’Over & Amp Control> (page 16)/
<Function Setting System> (page 29)/
<Equalizer Curve Adjustment> (page 18).
[#0] — [#9] buttons
Press buttons [#1] — [#3] to recall preset settings.
Refer to <Recalling the X’Over setting> (page 16)/
<Recalling the equalizer curve> (page 18).
DPX-8030MD_U.S_r3 02.3.22 3:14 PM Page 33