Konica Minolta bizhub 163 - Manual (Page 153)

7 Network settings
7-14 IC-206
4
Press the [OK] key.
After the message “ACCEPTED” appears, the “NETWORK SETTING”
menu appears again.
5
Press the [Reset] key in the control panel.
– After the screen shown above appears, turn the machine off, then
on again to restart it.
2
Reminder
In order to apply the new settings, the machine must be turned off, then
on again to be restarted.
Specifying the gateway transmission setting
1
In the “NETWORK SETTING” menu, press the [,] or [+] key until
“GATEWAY TX” is selected, and then press the [OK] key.
2
Press the [,] or [+] key until “DISABLE” or “ENABLE” is selected, and
then press the [OK] key.