Konica Minolta bizhub 163 - Manual (Page 187)

7 Network settings
7-48 IC-206
– If an NTP server was specified:
The date and time that data is sent with the Scan to E-Mail or Scan
to FTP operation are automatically added to the data at the same
time that the transmission date and time are recorded in the trans-
mission log.
– If an NTP server was not specified:
Only a transmission number is added to data sent with the Scan to
E-Mail or Scan to FTP operation; the transmission date and time are
not added to the data. In addition, the date and time are not record-
ed in the transmission log.
– For the NTP server address, consult with the network administrator.
The message “ACCEPTED” appears, and then the “USER SETTING”
menu appears again.
7
Press the [Reset] key.
The time is acquired from the NTP server, and then the time on the ma-
chine is set.
Specifying the time zone
1
Press the [Utility] key in the control panel.
2
Press the [,] or [+] key until “ADMIN. MANAGEMENT” is selected, and
then press the [OK] key.