Kodak MDV 300 - Manual (Page 6)

INTRODUCTION
LOADING BATTERIES INTO THE REMOTE CONTROL
Remove the battery compartment cover.
Load two AAA (UM-4 or R03) batteries into the
battery compartment.
Check that batteries are fitted correctly and that
the polarity of the batteries matches the polarity
indicated in the battery compartment. Replace
the battery compartment cover.
Always replace both batteries. Do not mix new
and used batteries as this will reduce the
operating period.
Remove the batteries if the unit is not be used
for a prolonged period of time.
Loading batteries into the remote control
The remote control transmits a directional
infrared beam. Be sure to aim the remote
control directly at the infrared sensor of the
unit during operation.
If th e sensor has been covered or there is a
large object between the remote control and
the sensor, the sensor may not respond.
The sensor m ay not able to receive the
remote signal when i t isexposed to direct
sunlight or a strong artificial light (fluorescent
or strobe light). I n these instances, change the
direction of the light or reposition the unit to
avoid direct lighting.
2
3
Within approximately
6 metres (20 feet)
STOP
OPEN/CLOSE
PLAY PAUSE SKIP
DVDPlayer
Accessories
Your MDV 300 is supplied w i t h the following
accessories:
- Separatemains power cord to suit country
of sale.
- My-Link interconnect (0.5m RCA-RCA).
- MDV 300 remote control handset.
- Two AAA batteries for handset
(not in some countries).
Introduction
The Myryad MDV 300DVD-Video Player has been
designed to offer a combination of high quality
sound reproduction and elegant styling in keeping
with otherMyryad products. The MDV 300 is a
full-function remote controlled DVD-Video player.
It has fixed-level low-impedance audio outputs to
drive a Myryad pre-amplifier or integrated amplifier
or other high quality amplifier. Video outputs are
provided in composite, s-video and component form
and can be fed to an audio-video preamplifier (such
as the Myryad M DP 500 G6) or amplifier or direct to
a TV. In addition the MDV 300 has coax and
optical digital outputs (SPDIF standard) to feed a
digital surround processor and a Smart My-Link
control input and output.
The M D V 300 offers a range of expansion
possibilities:
- The My-Link can be connected to a Myryad pre-
amplifier or integrated amplifier so that the
MDV 300 will be switched on or off when the
amplifier is switched on or off.
- The My-Link input/output can be coupled to
otherMyryad products that can then beremote-
controlled via the MDV 300’s infra-red receiver,
or vice-versa.
- When linked to a “Smart My-Link” compatible
Myryad preamplifier or integrated amplifier a
number of extra features become available
which m ake the system a s a whole easier and
quicker t o operate.