Function control – Kenwood KDC-BT8041U User Manual
Page 6
6
|
KDC-BT8041U/ KDC-BT8141U
Category Item
Setting
Entry
Setting overview
Condition Page
MENU
“Security Set”
1 sec.
Sets security code
20
“SRC Select”
“1”*/ “2”
Sets the source selection method.
34
“iPod Mode”
“OFF”/ “ON”*
When set to “ON”, allows you to select music in the manner
similar to that of the iPod.
12
“Device Regist”
1 sec.
Register a Bluetooth device (pairing).
25
“SPCL DVC
Select”
1 sec.
Allow registration of a special device that cannot be
registered normally.
25
“Phone
Selection”
1 sec.
Select a cell-phone subject to hands-free connection.
27
“Audio
Selection”
1 sec.
Select the Bluetooth audio player to be connected.
—
27
“Device Delete”
1 sec.
Cancel registration of the Bluetooth device.
27
“BT DVC Status”
1 sec.
Display the status of the Bluetooth device.
—
34
“PIN Code Edit”
1 sec.
Specify the PIN code required when registering this unit
using the Bluetooth device.
26
“Auto Answer” ”OFF”/ ”0s” – ”8s”*
– “99s”
Answer a call automatically after lapse of the preset time
interval for automatic answer.
34
“SP Select”
”Front”*/ ”F-R”/
”F-L”
Specify the voice output speaker.
34
“Call Beep”
”ON”*/ ”OFF”
Output a beep from the speaker when a call comes in.
34
“BT F/W
Update”
1 sec.
Display the firmware version and update the firmware.
27
“Beep”
“OFF”/ “ON”*
Setting the operation check sound (beep sound) ON/OFF.
“Clock Adjust”
1 sec.
Sets the clock.
21
“Date Adjust”
1 sec.
Sets the date.
21
“Date Mode”
7 types
1 sec.
Sets the date display mode.
“SYNC”
“OFF”/ “ON”*
Synchronizing the RDS station time data and this unit’s clock.
“Display”
“OFF”/ “ON”*
Turns off the display when no operation is performed.
—
34
“Dimmer”
“OFF”/ “ON”*
Dims the display part in conjunction with the light switch of
the vehicle.
“ILM Dimmer” “AUTO”*/ “MNAL1”/
“MNAL2”/ “OFF”
Sets whether the key illumination is dimmed in conjunction
with the light switch of the vehicle or it is dimmed constantly.
34
“ILM Effect”
“OFF”/ “ON”*
Sets whether the key illumination brightness is changed in
conjunction with the key operation.
“ILM MSC
SYNC”
“OFF”*/ “ON”
Sets whether the key illumination brightness is changed in
conjunction with the sound volume.
—
“SWPRE”
“Rear”*/ “Sub-W”
Sets the preout output.
34
“AMP”
“OFF”/ “ON”*
Turns on/off the built-in amplifier.
34
“Zone2”
“Rear”*/ “Front”
Specifies the destination of AUX input sound when the Dual
Zone function is turned on.
34
“Supreme”
“OFF”/ “ON”*
Turns ON/OFF the Supreme function.
34
“News”
“OFF”*/ “00min”
– “90min”
Turns ON/OFF the News Bulletin Automatic Reception
function and sets the news bulletin interrupt disabled time.
34
“Local Seek”
“OFF”*/ “ON”
Only stations whose reception is good are searched in auto
seek tuning.
“Seek Mode”
“Auto1”*/ “Auto2”/
“Manual”
Selects the tuning mode of the radio.
34
“AF”
“OFF”/ “ON”*
When station reception is poor, automatically switches to the
station that is broadcasting the same program over the same
RDS network.
35
Function Control
Functions in the table below can be set up by using Function Control.