Kenwood KDC-MP245 - Manual (Page 12)

12 | KDC-MP245/ KDC-MP145
Basic Operations of Remote Control
ATT
0 — 9
SRC
VOL
FM+ AM–
EXIT
 /O
AUD
ENT
DIRECT
General Control
Volume control: [VOL]
Source select: [SRC]
Volume reduce: [ATT]
When the button is pressed again, the volume returns
to the previous level.
Return to previous item: [ ]
Exit from mode: [EXIT]
Selection of item: [ 5]/[∞]
Determination: [ENT]
Enter Audio Control mode: [AUD]
In Tuner Source
Band select: [FM+]/[AM–]
Station select: [ 4]/[¢]
Recall preset stations: [1] — [6]
In CD/Audio File Source
Music select: [ 4]/[¢]
Folder select: [FM+]/[AM–]
Pause/Play: [ 38]
Movement between folders/files: [ 5]/[∞]
Return to previous folder: [ ]
Preparing the Remote Control Unit
Pull the battery sheet out from the remote control
unit to the direction of the arrow.
Changing the battery of the remote control
unit
Use a commercially available button battery (CR2025).
Insert something narrow like a paperclip into the hole
1 and pull out the battery tray.
Insert the battery with the + and – poles aligned
properly, following the illustration inside the case.
Keep on slide
Pull out
CR2025(+side)
Not used.
(page 11)
Accessory of KDC-MP245/ KDC-MP145CR
¤
CAUTION
• Do not set the remote control in hot places such
as on the dashboard.
• Lithium battery.
Danger of explosion if the battery is incorrectly
replaced.
Replace only with the same or equivalent type.
• The battery pack or batteries shall not be
exposed to excessive heat such sunshine, fire or
the like.
• Keep battery out of reach of children and in
original package until ready to use. Dispose of
used batteries promptly. If swallowed contact
physician immediately.
B64-4590-00_00_en.indd 12 09.10.8 10:48:26 AM