KTM EXC-F SIX DAYS EN - Manual (Page 32)

MAINTENANCE WORK ON CHASSIS AND ENGINE
»
ENGLISH
31
250 XC-F, XCF-W, EXC-F:
NOTE:
The position of the chain guide must be adjusted due to the large number of
rear sprockets available. Up to 44 teeth, insert the retaining screw on the
chain guide in the lower hole [C], from 45 teeth in the upper hole [D].
Loosen both screws on the chain guide and pull the chain guide off the swing
arm.
Turn the chain guide over, press out the retaining nut [4] and insert it in the
other hole [5], turning the retaining nut around.
Remount the chain guide and tighten the screws to 10 Nm.
C
D
4
5
Adapting the chain guide to the number of rear sprocket teeth
250 SX-F, EXC-F Six Days:
NOTE:
The position of the chain guide must be adjusted due to the large number of
rear sprockets available. Up to 44 teeth, insert the retaining screw on the
chain guide in the lower hole [A], from 45 teeth in the upper hole [B].
A
B
1
2
3
Loosen screw [1] and remove screw [2]. Tilt the chain guide down and insert
the collared bush [3] in the corresponding hole.
Torque the screws to 10 Nm.