Kenwood G-EQ300 - Manual (Page 16)

G-EQ300 (En/K)
1 6
Select the center frequency.
6
Adjust the level.
Select the inclination of the curve.
7
5
When adjustment of center frequencies F2 and/
or F3 is required:
8
9 8 H Z
400 625 1k 250 63 98 160
¶Pressing the FLAT key allows to start adjustment from the flat level
position.
NARROW WIDE
One the two
shall light up.
WIDE NARROW
400 625 1k 250 63 98 160 400 625 1k 250 63 98 160
2.5k 3.9k 6.3k 10k 16 k 400 625 1k 1.5k 250 40 63 98 160
2.5k 3.9k 6.3k 10k 16 k 400 625 1k 1.5k 250 40 63 98 160
¶One adjusted, the curve remains the same until next time it is pressed.
¶For finer adjustment, perform the graphic mode operation described
in the following page. &
Creation of desired equalizer patterns
Repeat steps 4 to 7 above for each center frequency.
Each press switches the display as follows.
1 WIDE : Curve with a gentle slope.
2 NARROW: Curve with a sharp slope.
When two curves F1 and F2 or three curves F1, F2 and F3 are set,
the curve combining them will be displayed in a few seconds.
FREQUENCY JOG
EQ.LEVEL
WIDE/NARROW