Ken-A-Vision 7700 - Manual (Page 4)

FAQ 8
I can't connect!
In the case of a connection failure, follow this sequence,
letting each device finish fully rebooting:
Modem Reboot
Router Reboot
7700 Reboot
How do I choose a unique IP address that matches my network?
For your home or small office, ensure that all devices on your
network are running. PING an IP address that you plan to assign to
the 7700. If you receive a "Request timed out", then you may use
that IP address. To ensure the IP address that you will assign the
7700 matches your network, review your "Current TCP/IP Settings"
that you had recorded earlier. See some examples below:
w If your "IP Address" entry in "Current TCP/IP Settings" was
192.168.0.y, and your "Subnet Mask" was 255.255.255.0 then
use 192.168.0.x for your 7700's IP Address ("x" meaning any
number between 2-254 that you wish, as long as it passes the
"PING" test).
w Other private IP ranges are 10.0.0.0 - 10.255.255.255 and
172.16.0.0 - 172.31.255.255.
How do I open an MS-DOS or Command Prompt?
w Windows 98 / ME Users:
Start ' Programs ' Accessories ' MS-DOS prompt
w Windows 2000 / XP Users:
Start ' (All) Programs ' Accessories ' Command Prompt
How do I "PING" an IP address?
w Open an MS-DOS (or Command) prompt
w At the prompt type - "ping xxx.xxx.xxx.xxx" (without the quotes
and replace the "x"s with an IP address)
w Press Enter
How do I enable or check ActiveX on my browser
Open Internet Explorer ' Tools on the menu bar ' Internet Options '
Security Tab ' Custom Level ' Scroll down and verify that you are
prompted or have enabled ActiveX controls and plug-ins to be
downloaded and executed ' Click OK ' Restart browser.
Network Video Flex ® 7700 Manual www.ken-a-vision.com
7700 INSTALLATION 2
Back Panel
Power Supply Connector
Use the power jack to connect your regulated 12V DC power
adapter.
10M LED
This green indicator should be flashing or glowing during
normal operation. During a reboot or power cycling, it may
take up to 30 seconds to initialize, negotiate your network
speed, and begin operation at 10Mbps. If this light is not lit
after 30 seconds of operation, check the network cable to
ensure a proper connection. When a proper connection is
met, the green indicator should immediately glow.
Network RJ45 Jack
The server is designed to operate on a 10/100 Mbps
Ethernet network. Currently the server operates at 10 Mbps
until future upgrades become available. This accepts
standard RJ45 plugs and works with Ethernet CAT5 cables.
Analog Video Jack
With this port you can connect the 7700 to an analog video
device such as a TV monitor, a LCD projector, or any other
device that can accept an analog video input. Use a
standard video RCA cable.
Network Video Flex ® 7700 Manual www.ken-a-vision.com
Frequently Asked Questions Product Description