Kathrein UFD 545 - Manual (Page 20)

Channel selection
20
Reception status - radio
After switching over the receiver, simply press the
ou
buttons to select
other radio channels in their ascending or descending order in the channel
memory.
Every time you press the button, an on-screen display shows you the selected
channel together with the time, the programme start and end times as well as the
channel title in the information box provided these data are transmitted together
with the signal.
By pressing the
O
button, you can leave
this information box permanently
displayed or switch it off by pressing the
button once again.
A further option of selecting a different channel is to press the
i
button. The
radio channel list is now displayed. In the left column it will provide information
relating to the received satellites, the transponder and its transmission frequency,
the polarization, the symbol rate and the scrambling of digital channels. The right
side shows the channel number, the channel broadcaster and the type of reception
signal (analogue/digital). By pressing the
ou
buttons you jump to the next
channel and by pressing the
-+
buttons you jump to the neighbouring page.
Confirm your channel selection by pressing the
O
button, press the
L
button to
exit the channel list and remain in the channel already set.
Selecting a radio channel by number entry
You can select a different radio channel during a current radio channel by entering
the channel location number. Use the number buttons
1
to
0
for the purpose
of entering the channel location number.
Example You wish to select the radio channel "DLR-Berlin". This channel is stored under the
channel location number 015. (The order of radio channels is defined in the
channel memory and therefore only serves as an example here.)
To select this channel, press the numbers
1
and
5
one after the other. The
receiver waits for about 3 seconds for entry of the next number.
Follow the same procedure for all other channels – i.e. also channels with three-
digit channel location numbers. You do not have to enter leading zeros.