Kuppersbusch USA EEB 9800.0 - Manual (Page 20)

20
EEB 9800.0 USA
Cleaning and Care
Carefully read this chapter before you use your appliance the first time. If it’s
cleaned properly and regularly, it will remain beautiful and clean for many
years. Here are a few tips for cleaning and maintaining the appliance surfaces.
For all surfaces
= Do not, under any circumstances, use steam or pressure cleaning
machines to clean the appliance! Damage caused to your appliance by
cleaning it this way can make it lethally dangerous.
= Risk of burning! Make sure the appliance has cooled down before
cleaning.
= Please follow the instructions provided with the cleaning agents you plan
to use.
Clean the appliance each time you use it. Dirt that isn’t removed will burn into
the surface when you switch it on again and will be difficult or impossible to
remove.
Use a damp cloth or a soft sponge with warm water and a little detergent to
clean light amounts of surface dirt. Always wipe off the surface completely
with cold water to remove residues from cleansers than can cause
discoloration and stains. Wipe dry afterwards.
F For information about cleaning individual surfaces and parts and removing
heavy dirt, review the information below.
F VSR O-FIX-C is perfect for the cleaning of glass ceramic, enamel and the
coated door interior. It is available from KÜPPERSBUSCH Customer
Service.
Do not use any
- Harsh cleansers or cleansers with bleach or active oxygen, chlorine or cor-
rosive components.
- Abrasive or harsh cleansers or scouring products like steel wool, soap-filled
steel wool, metal or plastic sponges or similar products with an abrasive
surface.
Remove caking
Be sure to soak any crusty food debris with a wet cloth. It will make it easier
to remove the dirt.
Information about the cleaning scraper
= Be careful! The blade of the cleaning scraper is very sharp and will cut!
Always keep the cleaning scraper flat on the
surface and push the dirt away.
= Don't scratch the surface with the edge of the
scraper and don't damage the sealing with
the edge.
The use of oven sprays - information
= Please follow the instructions from the manufacturer. Oven sprays dam-
age aluminum, lacquered surfaces and plastic!
= Do not spray into the opening of the ventilator at the backplate! The
ökotherm
®
catalyst will be destroyed if you use oven spray.
For environmental reasons, don’t use oven spray at all. However, if you do use
it, just spray it in the oven interior and on enamel baking trays.
Enamel
Oven interior, front, baking trays, drip pan
Some plastic sponges with an abrasive side can be used. However, some
products have grains in the abrasive side of the sponge that can scratch the
surface.
Test the sponge on a small surface before using!
F A cleaning scraper for glass ceramic surfaces is perfect for removing
heavy dirt.
F Use VSR O- FIX-C to clean your oven. Oven spray can also be used.
Stainless steel
Stainless steel door front, control panel, telescopic glide-out shelves
(acc. no. 601)
= Stainless steel is easily scratched!
Do not use a cleaning scraper!
= Remove any calcium deposits, grease spots and starch as soon as pos-
sible or stains will appear!
A cleanser for stainless steel is perfect. Be sure to clean the stainless steel
with a stainless steel cleanser at least once a week. This creates a protective
film for the stainless steel surface and will prevent discoloration.
You should clean the stainless steel surfaces with a stainless steel cleanser
at least once a week. This will create a protective film to prevent the stainless
steel surface from discoloring.
Glass
Inside of the door - coated glass
= Don’t use oven spray because it can destroy the coated glass surface if
used frequently.
To remove heavy dirt, use a cleaning scraper for glass ceramic surfaces.
F VSR O- FIX-C or glass detergent is ideal to clean your glass ceramic sur-
face.
Door front, control panel
F Using a damp cloth or soft sponge, clean the front of the oven with
warm water and a little detergent. You may use glass cleaners.
Aluminium
Door ledges and handles in aluminium
= Aluminium is very sensitiv to scratches and oven spray spray causes
damage!
Do not use a cleaning scraper!
Door sealing
F Since dirt can collect under the sealing, be sure to remove the door seal-
ing when cleaning the oven. See “Replacing the door sealing” on
page 23.
Clean the sealing with detergent or dishwashing liquid.
Knobs
Using a damp cloth or soft sponge, clean the knobs with warm water and a
little detergent.