Kuppersbusch USA EEB 9800.0 - Manual (Page 9)

EEB 9800.0 USA
9
Automatic turn-on and shut-off
If you wish use the oven’s time-delay feature, you may pre-select both cooking
time and finish time. The automatic start time itself cannot be specified, but
this is derived from both settings.
Example:
It is 8.00 and you wish to have your roast ready at 13.00. The roast needs to
be cooked for 90 minutes.
– Change the cooking time
u
from 0.00 to 1.30.
– Then change the finish time
n
from 9.30 to 13.00.
– Confirm with
j
.
The oven turns on at 11.30 and off at 13.00.
Change automatic weight
d
/ weight system
In the roasting programes and the ”Bread
Z
” baking programe, cooking time
and temperature can be selected dependent on the weight. The text display
requests you to select the weight of the food to be cooked.
In these programes, input weight immediately after selecting the
programe.
Switching the oven off
– Touch the key
e
.
The oven is switched off.
F If you have accidentally turned the oven off while a programe is running,
you can resume that programe.
Resuming interrupted programes
Did you accidentally turn the oven off while a programe was running?
– Switch the oven on again. The text display will ask you: <progr. interrupted!
Continue? OK>
– Confirm by touching
j
.
Blend in the actual oven temperature
– Touch the key
g
. The current oven temperature is briefly displayed.
Additional functions
Rapid heating
J
Use this function to have the oven heat at higher performance to the
temperature set.
F The ”Rapid heating”
J
function can be added in many heating
programes. (See ”Using your oven” on page 8.)
– Choose a heating programe and then touch ”Rapid heating”
J
. Both sensor
keys light up red.
– Select all the values as usual and confirm your input with
j
.
F When heating has completed, the illuminated ”Rapid heating” symbol
J
no longer shows red.
Memory function
M
/
N
The oven has a memory function you can use to store two programes you
have composed yourself as additional programes.
Saving an additional programe:
– Select a baking, roasting or heating programe.
– Set the desired temperature and time.
– Then select ”Rapid heating”
J
if applicable.
– Hold the memory sensor
M
or
N
depressed, until the text displays
<programe saved>.
The programe set can now be saved with
M
or
N
and can be used like
every other baking, roasting or heating programe.
Choosing an additional programe:
– Press the
M
or
N
sensor and confirm by touching
j
.
The programe starts.
The values set can be changed without such changes being saved.