Kohler Single-Control bath and Shower Trim K-T16116 - Manual (Page 4)

1. Install the Spout
CAUTION: Risk of internal seal damage. Do not use
petroleum-based lubricants when installing slip-fit spouts. If the
spout will not slide over the tubing, use soapy water or a
silicone-based lubricant.
Remove the temporary nipple.
Apply thread sealant and install a 1/2
″
nipple so it extends 7/16
″
(1.1 cm) beyond the finished wall.
Apply a bead of plumbers putty or other sealant around the inlet
end of the spout according to the manufacturer’s instructions.
Apply thread sealant to the nipple and thread the spout onto the
nipple.
Carefully tighten with a clean strap wrench.
Remove all excess putty.
Nipple
Apply plumbers
putty.
3-7/8"
(9.8 cm)
Threaded Spouts
1025255-2-C 4 Kohler Co.