Kohler Single-Control bath and Shower Trim K-T16116 - Manual (Page 6)

Install the Showerhead (cont.)
Installing the Nonstandard Showerhead
Remove the temporary nipple from the shower elbow.
Apply thread sealant tape and install a 1/2
″
NPT nipple to
extend 1/2
″
(1.3 cm) beyond the finished wall.
Apply a bead of plumbers putty or other sealant to the back of
the shower arm according to the manufacturer’s instructions.
Apply thread sealant tape to the nipple and thread the shower
arm onto the nipple.
Carefully tighten with a clean strap wrench.
Remove all excess putty.
With the showerhead off, flush out the system.
Apply thread sealant tape to the shower arm, and thread the
showerhead to the shower arm.
1025255-2-C 6 Kohler Co.