Kyocera TNT VMS200 - Manual (Page 55)

User Guide 47
13 V
OICE
C
OMMANDS
You can call a contact, dial a phone number,
access menus, or find contact information from
your voice dial list using voice commands.
Note: You cannot use voice recognition to end
a call; you must press the
End key when the flip
is open.
Voice dial list
To call or find a contact using voice dial, you must
add the contact to your voice dial list. The contact
name must not have more than five words or
components for voice recognition.
Add contacts
To add a contact to your voice dial list:
1.
Select Menu > Contacts > Voice dial list .
2. At the contact list, highlight a contact and
press the
OK key. A check mark appears
next to a name when voice dialing is active.
Check each name you want to use with
voice dialing.
3. Select Save .
Note: For a contact to be added to the voice dial
list, the Name field must not contain more than
five words or components, must not be blank, and
must include at least one letter.
Remove contacts
To add a contact to your voice dial list:
1.
Select Menu > Contacts > Voice dial list .
2. At the contact list, highlight a check marked
contact and press the
OK key. No check
mark appears next to a name when voice
dialing is inactive. Uncheck each name you
want to remove from voice dialing.
3. Select Save .
Voice commands
Start voice commands
1. Press and hold the Send key to initiate voice
commands. The phone prompts,
“Say a command”.
2. Say one of the following commands and
follow the voice prompts.
– “
Contact <name> ” calls a contact on
your voice dial list.
– “ Dial Number <#> ” calls by speaking
the digits of the phone number.
– “ <shortcut name> ” sends you to a
menu item.
– “ Find Contact ” allows you to find a
contact from your voice dial list.
Call a contact name
1. If you haven’t already done so, add the
person you want to call to the Voice Dial List.
See “Voice dial list” on page 47.
2. From the main screen, press and hold the
Send key. The phone prompts, “Say
a command”.
82-K8214-1EN.book Page 47 Tuesday, May 27, 2008 5:36 PM