King Kutter 999995 User Manual

Page 18

Advertising
background image

18

STEP 1

Cutting the PTO shaft to length.
NOTE: Be sure to cut equal
lengths of each PTO shaft section.
Clamp end of PTO shaft in a vice
and cut off shield where marked.
(Figure 1-A & 1-B)

STEP 2

Using cut section of the shield as
a guide cut shaft off the same
amount. (Figure 2)

STEP 3

Repeat steps 1 and 2 for other
PTO shaft section.

STEP 4

Use a file to deburr PTO shafts.
Clean up all chips, burrs and fil-
ings from both ends of the PTO
shaft.

SIZING PTO SHAFT

Figure 1-A

Figure 1-B

Figure 2

Advertising